آمار

تعداد نشریات31
تعداد شماره‌ها479
تعداد مقالات4,235
تعداد مشاهده مقاله7,136,361
تعداد دریافت فایل اصل مقاله4,800,317
Banaei, Mohammadreza, Golmohamadi, Mohamad, Afsharirad, Hadi. (1405). An Inductively Coupled Bidirectional DC-DC Converter With a Non-Pulsating Input Current for Renewable Energy Systems Energy Storage. سامانه مدیریت نشریات علمی, 14(3), 181-189. doi: 10.22098/joape.2024.14945.2142
Mohammadreza Banaei; Mohamad Golmohamadi; Hadi Afsharirad. "An Inductively Coupled Bidirectional DC-DC Converter With a Non-Pulsating Input Current for Renewable Energy Systems Energy Storage". سامانه مدیریت نشریات علمی, 14, 3, 1405, 181-189. doi: 10.22098/joape.2024.14945.2142
Banaei, Mohammadreza, Golmohamadi, Mohamad, Afsharirad, Hadi. (1405). 'An Inductively Coupled Bidirectional DC-DC Converter With a Non-Pulsating Input Current for Renewable Energy Systems Energy Storage', سامانه مدیریت نشریات علمی, 14(3), pp. 181-189. doi: 10.22098/joape.2024.14945.2142
Banaei, Mohammadreza, Golmohamadi, Mohamad, Afsharirad, Hadi. An Inductively Coupled Bidirectional DC-DC Converter With a Non-Pulsating Input Current for Renewable Energy Systems Energy Storage. سامانه مدیریت نشریات علمی, 1405; 14(3): 181-189. doi: 10.22098/joape.2024.14945.2142

An Inductively Coupled Bidirectional DC-DC Converter With a Non-Pulsating Input Current for Renewable Energy Systems Energy Storage

Journal of Operation and Automation in Power Engineering
مقاله 3، دوره 14، شماره 3، آبان 2026، صفحه 181-189    اصل مقاله (2.16 M)
نوع مقاله: Research paper
شناسه دیجیتال (DOI): 10.22098/joape.2024.14945.2142
نویسندگان
Mohammadreza Banaei* ؛ Mohamad Golmohamadi؛ Hadi Afsharirad
Department of Electrical Engineering, Azarbaijan Shahid Madani University, Tabriz, Iran.
چکیده
The present study proposes a bidirectional DC-DC converter (BDC) that uses a non-isolated coupled-inductor (NI-CI). This converter can transfer power bidirectionally between the DC bus of a microgrid, supplied by PV or other renewable sources and energy storage system. The device exhibits a high voltage conversion ratio while using a few components. The converter applies the input inductance as a current ripple filter and uses a CI configuration to enhance the gain in boost mode. Also, the turns ratio of a coupled inductor is implemented to enhance the voltage conversion ratio to lower voltage stress. In addition, the converter’s operation is more efficient considering its soft-switching advantages. The duty cycle control is applied to generate the desired voltage on both sides of the converter by controlling the corresponding power switch. It is worth noting that the low-voltage side current ripple is not significant. Besides, the results show an increase in voltage gain throughout boost mode and a decrease in voltage gain in the buck mode. Furthermore, the converter is mathematically studied in the following, and a PID converter is designed to illustrate the converter’s stability. Finally, the practicality of the proposed NI-CI-BDC structure was validated by incorporating experimental results from a 200-watt prototype.
کلیدواژه‌ها
Optimal load distribution؛ decision theory with information gap؛ uncertainty؛ wind farm
مراجع
  1. M. R. Banaei and H. A. F. Bonab, “A high efficiency nonisolated buck–boost converter based on zeta converter,” IEEE Trans. Ind. Electron., vol. 67, no. 3, pp. 1991–1998, 2019.
  2. S. G. Sani, M. R. Banaei, and S. H. Hosseini, “Investigation and implementation of a common ground dc-dc buck converter with a novel control method for loss reduction in the converter,” IET Power Electron., 2024.
  3. M. R. Banaei, M. Golmohamadi, and H. Afsharirad, “A bidirectional high voltage ratio dc–dc topology for energy storage systems in microgrid,” IET Power Electron., vol. 17, no. 2, pp. 281–294, 2024.
  4. S. You, Z. Wang, and Y. Sun, “Charging strategy of an integrated onboard ev charger with a small intermediate capacitor,” CSEE J. Power Energy Syst., 2023.
  5. M. Yaqoob, K. H. Loo, and Y. Lai, “Extension of softswitching region of dual-active-bridge converter by a tunable resonant tank,” IEEE Tran. Power Electron., vol. 32, no. 12, pp. 9093–9104, 2017.
  6. R. Rezaii, M. Nilian, M. Safayatullah, F. Alaql, and I. Batarseh, “Design and experimental study of a high voltage gain bidirectional dc-dc converter for electrical vehicle application,” in 2022 IEEE Appl. Power Electron. Conf. Exposition, pp. 2058–2063, IEEE, 2022.
  7. M. Banaei, H. Ajdar Faeghi Bonab, and N. Taghizadegan Kalantari, “Analysis and design of a new single switch non-isolated buck-boost dc-dc converter,” J. Oper. Autom. Power Eng., vol. 8, no. 2, pp. 116–127, 2020.
  8. Z. Yan, J. Zeng, W. Lin, and J. Liu, “A novel interleaved nonisolated bidirectional dc–dc converter with high voltagegain and full-range zvs,” IEEE Trans. Power Electron., vol. 35, no. 7, pp. 7191–7203, 2019.
  9. C.-C. Lin, L.-S. Yang, and G. Wu, “Study of a non-isolated bidirectional dc–dc converter,” IET Power Electron., vol. 6, no. 1, pp. 30–37, 2013.
  10. F. G. Nimitti, J. C. Giacomini, and A. M. S. S. Andrade, “Dual-stacked bidirectional boost/buck dc–dc converter,” IEEE Trans. Ind. Electron., vol. 70, no. 9, pp. 8873–8882, 2022.
  11. Y.-T. Chen, Z.-X. Lu, and R.-H. Liang, “Analysis and design of a novel high-step-up dc/dc converter with coupled inductors,” IEEE Trans. Power Electron., vol. 33, no. 1, pp. 425–436, 2017.
  12. C.-M. Hong, L.-S. Yang, T.-J. Liang, and J.-F. Chen, “Novel bidirectional dc-dc converter with high step-up/down voltage gain,” in 2009 IEEE Energy Convers. Congr. Exposition, pp. 60–66, IEEE, 2009.
  13. F. Wu, S. Fan, X. Li, and S. Luo, “Bidirectional buck–boost current-fed isolated dc–dc converter and its modulation,” IEEE Trans. Power Electron., vol. 35, no. 5, pp. 5506–5516, 2019.
  14. M. R. Banaei and S. G. Sani, “Analysis and implementation of a new sepic-based single-switch buck–boost dc–dc converter with continuous input current,” IEEE Trans. Power Electron., vol. 33, no. 12, pp. 10317–10325, 2018.
  15. P. S. Kulasekaran and S. Dasarathan, “Design and analysis of interleaved high-gain bi-directional dc–dc converter for microgrid application integrated with photovoltaic systems,” Energies, vol. 16, no. 13, p. 5135, 2023.
  16. B. Krishna, G. Lithesh, and V. Karthikeyan, “A novel highgain bidirectional dc–dc converter for ev onboard charger applications,” Int. J. Circuit Theory Appl., vol. 50, no. 7, pp. 2531–2547, 2022.
  17. Y. Zhang, W. Zhang, F. Gao, S. Gao, and D. J. Rogers, “A switched-capacitor interleaved bidirectional converter with wide voltage-gain range for super capacitors in evs,” IEEE Trans. Power Electron., vol. 35, no. 2, pp. 1536–1547, 2019.
  18. N. A. Madiseh, E. Adib, and M. R. Amini, “A novel soft switching non-isolated bidirectional dc–dc converter without any extra auxiliary switch,” IEEE J. Emerging Sel. Top. Power Electron., vol. 12, no. 2, pp. 1875–1882, 2023.
  19. W. Hu, J. Tao, Z. Ding, and H. Yang, “Analysis and control of partial power processing nonisolated bidirectional dc-dc converter,” Int. J. Circuit Theory Appl., vol. 51, no. 9, pp. 4427–4441, 2023.
  20. M. Z. Malik, S. Zhang, Y. Hong, A. R. A. Alwahkyan, A. Ali, and A. Farooq, “A coupled inductor-based bidirectional dc-dc converter with step-up step-down operation for electric vehicle applications,” Int. Trans. Electr. Energy Syst., vol. 2023, no. 1, p. 9277881, 2023.
  21. H. Shayeghi, R. Mohajery, and N. Bizon, “Analysis and implementation of a high step-up dc-dc converter integrating
    a hybrid voltage multiplier cell and a coupled inductor,” J. Oper. Autom. Power Eng., 2024.
  22. H. Shayeghi, S. Pourjafar, S. Hashemzadeh, and F. Sedaghati, “A dc-dc converter with high voltage conversion ratio recommended for renewable energy application,” J. Oper. Autom. Power Eng., vol. 12, no. 3, pp. 186–194, 2024.
  23. N. Bagheri, B. Tousi, and S. Alilou, “A topology of nonisolated soft switched dc-dc converter for renewable energy applications,” J. Oper. Autom. Power Eng., 2024.
  24. M. Biswas, H.-C. Kim, and J.-W. Park, “A coupled inductor based high step-down/step-up dc-dc nonisolated bidirectional converter with reduced ripple in current and voltage stress,” IEEE J. Emerging Sel. Top. Power Electron., 2024.
  25. K. Farajzadeh, L. Mohammadian, S. Shahmohammadi, and T. Abedinzadeh, “A novel bidirectional dc–dc converter with high voltage conversion ratio and capability of cancelling input current ripple,” IET Power Electron., vol. 17, no. 3, pp. 375–393, 2024.
آمار
تعداد مشاهده مقاله: 714
تعداد دریافت فایل اصل مقاله: 413


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب