- M. Kim and S. Choi, “A fully soft-switched single switch isolated dc–dc converter,” IEEE Trans. Power Electron., vol. 30, no. 9, pp. 4883–4890, 2014.
- S. M. Hashemzadeh, S. H. Hosseini, E. Babaei, and M. Sabahi, “Design and modelling of a new three winding coupled inductor based high step-up dc–dc converter for renewable energy applications,” IET Power Electron., vol. 15, no. 13, pp. 1322–1339, 2022.
- S. M. Hashemzadeh, V. Marzang, S. Pourjafar, and S. H. Hosseini, “An ultra high step-up dual-input single-output dc–dc converter based on coupled inductor,” IEEE Trans. Ind. Electron., vol. 69, no. 11, pp. 11023–11034, 2021.
- S.-M. Chen, T.-J. Liang, L.-S. Yang, and J.-F. Chen, “A boost converter with capacitor multiplier and coupled inductor for ac module applications,” IEEE Trans. Ind. Electron., vol. 60, no. 4, pp. 1503–1511, 2011.
- H. Shayeghi, S. Pourjafar, S. M. Hashemzadeh, and F. Blaabjerg, “A high efficiency soft-switched dc–dc converter with high voltage conversion ratio,” Int. J. Circuit Theory Appl., vol. 49, no. 2, pp. 244–266, 2021.
- K.-B. Park, G.-W. Moon, and M.-J. Youn, “Nonisolated high step-up boost converter integrated with sepic converter,” IEEE Trans. Power Electron., vol. 25, no. 9, pp. 2266–2275, 2010.
- S.-M. Chen, M.-L. Lao, Y.-H. Hsieh, T.-J. Liang, and K.-H. Chen, “A novel switched-coupled-inductor dc–dc step-up converter and its derivatives,” IEEE Trans. Ind. Appl., vol. 51, no. 1, pp. 309–314, 2014.
- A. Samadian, S. M. Hashemzadeh, M. G. Marangalu, M. Maalandish, and S. H. Hosseini, “A new dual-input high step-up dc–dc converter with reduced switches stress and low input current ripple,” IET Power Electron., vol. 14, no. 9, pp. 1669–1683, 2021.
- A. Kumar and P. Sensarma, “Ripple-free input current high voltage gain dc–dc converters with coupled inductors,” IEEE Trans. Power Electron., vol. 34, no. 4, pp. 3418–3428, 2018.
- T.-J. Liang, J.-H. Lee, S.-M. Chen, J.-F. Chen, and L.-S. Yang, “Novel isolated high-step-up dc–dc converter with voltage lift,” IEEE Trans. Ind. Electron., vol. 60, no. 4, pp. 1483–1491, 2011.
- F. Sadaghati, H. Shayeghi, S. Pourjafar, and S. Hashemzadeh, “A high step-up transformer-less dc-dc converter with continuous input current,” in 2020 11th Power Electron. Drive Syst. Technol. Conf. (PEDSTC), pp. 1–6, IEEE, 2020.
- H. Shayeghi, S. Pourjafar, and S. M. Hashemzadeh, “A switching capacitor based multi-port bidirectional dc–dc converter,” IET Power Electron., vol. 14, no. 9, pp. 1622– 1636, 2021.
- V. Marzang, S. M. Hashemzadeh, P. Alavi, A. KhoshkbarSadigh, S. H. Hosseini, and M. Z. Malik, “A modified triple-switch triple-mode high step-up dc–dc converter,” IEEE Trans. Ind. Electron., vol. 69, no. 8, pp. 8015–8027, 2021.
- S. M. Hashemzadeh, S. H. Hosseini, E. Babaei, and M. Sabahi, “Design and modelling of a new three winding coupled inductor based high step-up dc–dc converter for renewable energy applications,” IET Power Electron., vol. 15, no. 13, pp. 1322–1339, 2022.
- S. M. Hashemzadeh, E. Babaei, S. H. Hosseini, and M. Sabahi, “On this page,” Int. Trans. Electr. Energy Syst., vol. 2, p. 3, 2022.
- S. Hou, J. Chen, T. Sun, and X. Bi, “Multi-input step-up converters based on the switched-diode-capacitor voltage accumulator,” IEEE Trans. Power Electron., vol. 31, no. 1, pp. 381–393, 2015.
- G. Wu, X. Ruan, and Z. Ye, “Nonisolated high step-up dc–dc converters adopting switched-capacitor cell,” IEEE Trans. Ind. Electron., vol. 62, no. 1, pp. 383–393, 2014.
- H.-K. Liao, T.-J. Liang, L.-S. Yang, and J.-F. Chen, “Noninverting buck–boost converter with interleaved technique for fuel-cell system,” IET Power Electron., vol. 5, no. 8, pp. 1379–1388, 2012.
- K. Hwu and T. Peng, “A novel buck–boost converter combining ky and buck converters,” IEEE Trans. Power Electron., vol. 27, no. 5, pp. 2236–2241, 2011.
- K.-I. Hwu and W.-Z. Jiang, “Analysis, design and derivation of a two-phase converter,” IET Power Electron., vol. 8, no. 10, pp. 1987–1995, 2015.
- M. A. Salvador, T. B. Lazzarin, and R. F. Coelho, “High stepup dc–dc converter with active switched-inductor and passive switched-capacitor networks,” IEEE Trans. Ind. Electron., vol. 65, no. 7, pp. 5644–5654, 2017.
- J. C. Rosas-Caro, J. E. Valdez-Resendiz, J. C. MayoMaldonado, A. Alejo-Reyes, and A. Valderrabano-Gonzalez, “Quadratic buck–boost converter with positive output voltage and minimum ripple point design,” IET Power Electron., vol. 11, no. 7, pp. 1306–1313, 2018.
- M. Maalandish, E. Babaei, P. Abolhasani, M. Gheisarnejad, and M.-H. Khooban, “Ultra high step-up soft-switching dc/dc converter using coupled inductor and interleaved technique,” IET Power Electron., 2023.
- H. Shayeghi, S. Pourjafar, S. Hashemzadeh, and F. Sedaghati, “A dc-dc converter with high voltage conversion ratio recommended for renewable energy application,” J. Oper. Autom. Power Eng., vol. 12, no. 3, pp. 186–194, 2024.
- A. Yaqoub Hamza and F. Jumaa, “A new transformerless dc-dc converter for renewable energy applications,” J. Oper. Autom. Power Eng., vol. 12, no. 1, pp. 35–41, 2024.
- R. W. Erickson and D. Maksimovic, Fundamentals of power electronics. Springer Science & Business Media, 2007.
- M. B. Meier, S. A. da Silva, A. A. Badin, E. F. R. Romaneli, and R. Gules, “Soft-switching high static gain dc–dc converter without auxiliary switches,” IEEE Trans. Ind. Electron., vol. 65, no. 3, pp. 2335–2345, 2017.
- Y. Tang, D. Fu, J. Kan, and T. Wang, “Dual switches dc/dc converter with three-winding-coupled inductor and charge pump,” IEEE Trans. Power Electron., vol. 31, no. 1, pp. 461–469, 2015.
- M. Heidari, H. Farzanehfard, and M. Esteki, “A single-switch single-magnetic core high conversion ratio converter with low input current ripple and wide soft-switching range for photovoltaic applications,” IEEE Trans. Power Electron., vol. 35, no. 7, pp. 7226–7234, 2019.
- F. Sedaghati and S. Pourjafar, “Analysis and implementation of a boost dc–dc converter with high voltage gain and continuous input current,” IET Power Electron., vol. 13, no. 4, pp. 798–807, 2020.
|