آمار

تعداد نشریات26
تعداد شماره‌ها391
تعداد مقالات3,430
تعداد مشاهده مقاله5,270,408
تعداد دریافت فایل اصل مقاله3,604,620
Gholipour, A., Ghanbari, M., Alibeiki, E., Jannati, M.. (1402). Sensorless FOC Strategy for Current Sensor Faults in Three-Phase Induction ‎Motor Drives. سامانه مدیریت نشریات علمی, 11(1), 1-10. doi: 10.22098/joape.2022.9274.1648
A. Gholipour; M. Ghanbari; E. Alibeiki; M. Jannati. "Sensorless FOC Strategy for Current Sensor Faults in Three-Phase Induction ‎Motor Drives". سامانه مدیریت نشریات علمی, 11, 1, 1402, 1-10. doi: 10.22098/joape.2022.9274.1648
Gholipour, A., Ghanbari, M., Alibeiki, E., Jannati, M.. (1402). 'Sensorless FOC Strategy for Current Sensor Faults in Three-Phase Induction ‎Motor Drives', سامانه مدیریت نشریات علمی, 11(1), pp. 1-10. doi: 10.22098/joape.2022.9274.1648
Gholipour, A., Ghanbari, M., Alibeiki, E., Jannati, M.. Sensorless FOC Strategy for Current Sensor Faults in Three-Phase Induction ‎Motor Drives. سامانه مدیریت نشریات علمی, 1402; 11(1): 1-10. doi: 10.22098/joape.2022.9274.1648

Sensorless FOC Strategy for Current Sensor Faults in Three-Phase Induction ‎Motor Drives

Journal of Operation and Automation in Power Engineering
دوره 11، شماره 1، تیر 2023، صفحه 1-10    اصل مقاله (1.11 M)
نوع مقاله: Research paper
شناسه دیجیتال (DOI): 10.22098/joape.2022.9274.1648
نویسندگان
A. Gholipour1؛ M. Ghanbari* 1؛ E. Alibeiki1، 2؛ M. Jannati1
1Department of Electrical Engineering, Gorgan Branch, Islamic Azad University, Gorgan, Iran
2Department of Electrical Engineering, Aliabad Katoul Branch, Islamic Azad University, Aliabad Katoul, Iran
چکیده
Current sensors are required in Field-Oriented Control (FOC) strategies of Three-Phase Induction Motor (TPIM) drives. Nevertheless, the current sensors are subject to different electrical/mechanical faults which reduce the safety and dependability of the drive system. Single phase current sensor Fault-Tolerant Control (FTC) for sensorless TPIM drives using flux observer and Extended Kalman Filter (EKF) is proposed in this research. In the suggested FTC scheme, current sensor fault detection is based on axes transformation, a logic circuit is served as the fault isolation and reconstruction of faulted currents are achieved through flux observer and EKF. The presented FTC system is capable of detecting and localizing the current sensor fault and switching the drive system to tolerant FOC mode without the rotor speed measurement. The effectiveness of the suggested FTC system is confirmed by experiments on a 0.75kW TPIM drive platform.
کلیدواژه‌ها
Current Sensor Fault؛ EKF؛ Flux Observer؛ Sensorless Control؛ Induction Motor
مراجع
  1. Moayedirad and S. Nejad, “Increasing the efficiency of the power electronic converter for a proposed dual stator winding squirrel-cage induction motor drive using a five-leg inverter at low speeds”, J. Oper. Autom. Power Eng., vol. 6, no. 1, pp. 23-39, 2018.
  2. Tabasian et al., “Direct field-oriented control strategy for fault-tolerant control of induction machine drives based on EKF”, IET Electr. Power Appl., 2020.
  3. Shabandokht-Zarami et al., “An improved FOC strategy for speed control of induction motor drives under‎ an open-phase fault using genetic algorithm‎”, J. Oper. Autom. Power Eng., vol. 10, no. 1, pp. 80-89, 2022.
  4. Nikpayam et al., “Fault-tolerant control of Y-connected three-phase induction motor drives without speed measurement”, Measure., vol. 149, pp. 1-14, 2020.
  5. Ammar et al., “Feedback linearization based sensorless direct torque control using stator flux MRAS-sliding mode observer for induction motor drive”, ISA Trans., vol. 98, pp. 382-92, 2020.
  6. Jouili et al., “Luenberger state observer for speed sensorless ISFOC induction motor drives”, Electr. Power Syst. Res., vol. 89, pp. 139-47, 2012.
  7. Pal and S. Das, “Development of energy efficient scheme for speed sensorless induction motor drive”, Int. Trans. Electr. Energy Syst., 2020.
  8. Zhang et al., “Sensorless direct field-oriented control of three-phase induction motors based on "Sliding Mode" for washing-machine drive applications”, IEEE Trans. Ind. Appl., vol. 42, no. 3, pp. 694-701, 2006.
  9. Sun, D. Xu, and D. Jiang, “Observability analysis for speed sensorless induction motor drives with and without virtual voltage injection”, IEEE Trans. Power Electron., vol. 34, no. 9, pp. 9236-46, 2018.
  10. Holtz, “Sensorless control of induction machines—with or without signal injection?”, IEEE Trans. Ind. Electron., vol. 53, no. 1, pp. 7-30, 2006.
  11. Hinkkanen, V. Leppanen, and J. Luomi, “Flux observer enhanced with low-frequency signal injection allowing sensorless zero-frequency operation of induction motors”, IEEE Trans. Ind. Appl., vol. 41, no. 1, pp. 52-59, 2005.
  12. Yu et al., “Current sensor fault diagnosis and tolerant control for VSI-based induction motor drives”, IEEE Trans. Power Electron., vol. 33, pp. 4238-48, 2017.
  13. Gouichiche et al., “Global fault-tolerant control approach for vector control of an induction motor”, Int. Trans. Electr. Energy Syst., 2020.
  14. Raisemche et al., “Two active fault-tolerant control schemes of induction-motor drive in EV or HEV”, IEEE Trans. Veh. Tech., vol. 63, no. 1, pp. 19-29, 2013.
  15. Oubellil and M. Boukhnifer, “Passive fault tolerant control design of energy management system for electric vehicle”, 2014 IEEE 23rd Int. Symp. Ind. Electron., Istanbul, Turkey, 2014.
  16. Amin and K. Hasan, “A review of fault tolerant control systems: advancements and applications”, Measure., vol. 143, pp. 58-68, 2019.
  17. Gangsar and R. Tiwari, “Signal based condition monitoring techniques for fault detection and diagnosis of induction motors: A state-of-the-art review”, Mech. Syst. Signal Proc., vol. 144, pp. 1-37, 2020.
  18. Jannati et al., “Experimental evaluation of FOC of 3-phase IM under open-phase fault”, Int. J. Electron., vol. 104, no. 10, pp. 1675-88, 2017.
  19. Zhou et al., “An embedded closed-loop fault-tolerant control scheme for nonredundant vsi-fed induction motor drives”, IEEE Trans. Power Electron., vol. 32, no. 5, pp. 3731-40, 2016.
  20. Campos-Delgado, D. Espinoza-Trejo, and E. Palacios, “Fault-tolerant control in variable speed drives: a survey”, IET Electr. Power Appl., vol. 2, no. 2, pp. 121-34, 2008.
  21. Cherif et al., “Indirect vector controlled of an induction motor using H∞ current controller for IGBT open circuit fault compensation”, Int. Trans. Electr. Energy Syst., 2020.
  22. Bernieri et al., “A neural network approach to instrument fault detection and isolation”, IEEE Trans. Instrument. Measure., vol. 44, no. 3, pp. 747-50, 1995.
  23. Klimkowski and M. Dybkowski, “Neural network approach for stator current sensor fault detection and isolation for vector controlled induction motor drive”, Int. Power Electron. Motion Control Conf., Bulgaria, 2016.
  24. Li, A. Monti, and F. Ponci, “A fuzzy-based sensor validation strategy for AC motor drives”, IEEE Trans. Ind. Inf., vol. 8, no. 4, pp. 839-48, 2012.
  25. Salmasi, “A self-healing induction motor drive with model free sensor tampering and sensor fault detection, isolation, and compensation”, IEEE Trans. Ind. Electron., vol. 64, no. 8, pp. 6105-15, 2017.
  26. Chakraborty and V. Verma, “Speed and current sensor fault detection and isolation technique for induction motor drive using axes transformation”, IEEE Trans. Ind. Electron., vol. 62, no. 3, pp. 1943-54, 2014.
  27. Liu, M. Stettenbenz, and A. Bazzi, “Smooth fault-tolerant control of induction motor drives with sensor failures”, IEEE Trans. Power Electron., vol. 34, no. 4, pp. 3544-52, 2018.
  28. Tabbache et al., “A control reconfiguration strategy for post-sensor FTC in induction motor-based EVs”, IEEE Trans. Veh. Tech., vol. 62, no. 3, pp. 965-71, 2012.
  29. Manohar and S. Das, “Current sensor fault-tolerant control for direct torque control of induction motor drive using flux-linkage observer”, IEEE Tran. Ind. Inf., vol. 13, no. 6, pp. 2824-33, 2017.
  30. Lu et al., “Independent phase current reconstruction strategy for IPMSM sensorless control without using null switching states”, IEEE Trans. Ind. Electron., vol. 65, no. 6, pp. 4492-4502, 2017.
  31. Zhang et al., “Sensor fault detection, isolation and system reconfiguration based on extended Kalman filter for induction motor drives”, IET Electr. Power Appl., vol. 7, no. 7, pp. 607-17, 2013.
  32. Zhang et al., “Current sensor fault-tolerant control for encoderless IPMSM drives based on current space vector error reconstruction”, IEEE J. Emerg. Selected Top. Power Electron., vol. 8, no. 4, pp. 3658-68, 2019.
  33. Wu et al., “A signal-based fault detection and tolerance control method of current sensor for PMSM drive”, IEEE Trans. Ind. Electron., vol. 65, no. 12, pp. 9646-57, 2018.
  34. Bose, Modern power electronics and AC drives. Prentice hall. 2002.
آمار
تعداد مشاهده مقاله: 1,249
تعداد دریافت فایل اصل مقاله: 1,370


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب