آمار

تعداد نشریات26
تعداد شماره‌ها373
تعداد مقالات3,302
تعداد مشاهده مقاله4,894,590
تعداد دریافت فایل اصل مقاله3,350,708
Rostami, Naghi, Kadhim, Amjed A., Bannae-Sharifian, Mohammad Bagher. (1404). Cogging Force Reduction in PMLSMs Using Segmented Magnets. سامانه مدیریت نشریات علمی, 13(3), 206-211. doi: 10.22098/joape.2024.14267.2098
Naghi Rostami; Amjed A. Kadhim; Mohammad Bagher Bannae-Sharifian. "Cogging Force Reduction in PMLSMs Using Segmented Magnets". سامانه مدیریت نشریات علمی, 13, 3, 1404, 206-211. doi: 10.22098/joape.2024.14267.2098
Rostami, Naghi, Kadhim, Amjed A., Bannae-Sharifian, Mohammad Bagher. (1404). 'Cogging Force Reduction in PMLSMs Using Segmented Magnets', سامانه مدیریت نشریات علمی, 13(3), pp. 206-211. doi: 10.22098/joape.2024.14267.2098
Rostami, Naghi, Kadhim, Amjed A., Bannae-Sharifian, Mohammad Bagher. Cogging Force Reduction in PMLSMs Using Segmented Magnets. سامانه مدیریت نشریات علمی, 1404; 13(3): 206-211. doi: 10.22098/joape.2024.14267.2098

Cogging Force Reduction in PMLSMs Using Segmented Magnets

Journal of Operation and Automation in Power Engineering
مقاله 3، دوره 13، شماره 3، 2025، صفحه 206-211    اصل مقاله (659.47 K)
نوع مقاله: Research paper
شناسه دیجیتال (DOI): 10.22098/joape.2024.14267.2098
نویسندگان
Naghi Rostami* ؛ Amjed A. Kadhim؛ Mohammad Bagher Bannae-Sharifian
Faculty of Electrical and Computer Engineering, University of Tabriz, Tabriz, Iran
چکیده
Permanent Magnet Linear Synchronous Motors (PMLSMs) suffer from inevitable cogging force, especially in low-speed applications. In this paper, a new PMLSM is presented that uses segmented magnets instead of typically used rectangular magnets. This results in a significant reduction in cogging force and improved back EMF waveform. However, with these types of magnets, the actual three-dimensional (3D) structure of the machine cannot be reduced to a 2D problem because the thickness of the magnets varies with the depth of the device. Although 3D Finite Element Analysis (FEA) can be used, this method is very time-consuming even for one calculation step, which makes it difficult to use in optimization processes. To overcome these challenges, quasi-3D approach is used to transform the actual 3D structure of the machine into several 2D models and find the overall performance by combining the results obtained for each 2D problem. Genetic algorithm combined with quasi-3D method is used to find the appropriate thickness of each PM segment.
کلیدواژه‌ها
Permanent magnet linear motor؛ cogging force؛ segmented surfaced-mounted PMLSMs
مراجع
  1. Qian, L. Bao, C. Ji, and J. Wu, “Magnetic field modeling and analysis for permanent magnet synchronous linear motors,” Int. J. Appl. Electromagn. Mech., vol. 60, no. 2, pp. 209–221, 2019.
  2. Cao, Y. Jin, M. Lu, and Z. Zhang, “Quantitative comparison of linear flux-switching permanent magnet motor with linear induction motor for electromagnetic launch system,” IEEE Trans. Ind. Electron., vol. 65, no. 9, pp. 7569–7578, 2018.
  3. Cui, Z. Sun, W. Xu, W. Zhou, and Y. Liu, “Comparative analysis of bilateral permanent magnet linear synchronous motors with different structures,” CES Trans. Electr. Mach. Syst., vol. 4, no. 2, pp. 142–150, 2020.
  4. He, F. Dong, J. Zhao, L. Wang, J. Song, Q. Wang, and X. Song, “Thrust ripple reduction in permanent magnet synchronous linear motor based on tuned viscoelastic damper,” IEEE Trans. Ind. Electron., vol. 66, no. 2, pp. 977–987, 2018.
  5. Taskin, Design and implementation of a double-sided coreless linear motor. PhD thesis, Thèse de doctorat, Istanbule Technical University Graduate School of Science , 2015.
  6. G. Hayes and G. A. Goodarzi, “Electric powertrain: energy systems, power electronics and drives for hybrid, electric and fuel cell vehicles,” 2018.
  7. Torrent, J. I. Perat, and J. A. Jiménez, “Permanent magnet synchronous motor with different rotor structures for traction motor in high speed trains,” Energies, vol. 11, no. 6, p. 1549, 2018.
  8. Meng, Y. Yuan, Y. Sun, H. Liu, and Z. Zhu, “A novel method to reduce of cogging force in a linear flux-switching permanent magnet brushless ac machine,” J. Electr. Eng. Technol., vol. 14, pp. 653–662, 2019.
  9. Zeng, J. Zhao, S. Yan, and Y. Mao, “Research on cogging force suppression for toroidal pmlsm based on disturbance observer,” CES Trans. Electr. Mach. Syst., 2023.
  10. Sumega, P. Rafajdus, and M. Stulrajter, “Current harmonics controller for reduction of acoustic noise, vibrations and torque ripple caused by cogging torque in pm motors under foc operation,” Energies, vol. 13, no. 10, p. 2534, 2020.
  11. Hao, G. Zhang, W. Liu, H. Liu, and Y. Wang, “Methods for reducing cogging force in permanent magnet machines: A review,” Energies, vol. 16, no. 1, p. 422, 2022.
  12. Liu, X. Wang, Z. Xing, A. Yu, and C. Li, “Reduction of cogging torque and electromagnetic vibration based on different combination of pole arc coefficient for interior permanent magnet synchronous machine,” CES Trans. Electr. Mach. Syst., vol. 5, no. 4, pp. 291–300, 2021.
  13. Xu, Z. Sun, B. Du, and L. Ai, “Pole optimization and thrust ripple suppression of new halbach consequent-pole pmlsm for ropeless elevator propulsion,” IEEE Access, vol. 8, pp. 62042–62052, 2020.
  14. Huang, T. Ji, L. Li, B. Zhou, Z. Zhang, D. Gerada, and C. Gerada, “Detent force, thrust, and normal force of the short-primary double-sided permanent magnet linear synchronous motor with slot-shift structure,” IEEE Trans. Energy Convers., vol. 34, no. 3, pp. 1411–1421, 2019.
  15. Li and T. Ching, “A new segmented-stator linear vernier permanent magnet machine for direct-drive applications,” in 2017 IEEE Int. Electr. Mach. Drives Conf. (IEMDC), pp. 1–6, IEEE, 2017.
  16. Wang, J. Zhao, J. Song, F. Dong, K. Zong, and G. Li, “Thrust performance improvement for pmslm through doublelayer reverse skewed coil and wrf-mkh method,” IEEE/ASME Trans. Mechatron., vol. 25, no. 6, pp. 2950–2960, 2020.
  17. Deng, C. Ye, J. Yang, S. Sun, and D. Yu, “A novel permanent magnet linear motor for the application of electromagnetic launch system,” IEEE Trans. Appl. Supercond., vol. 30, no. 4, pp. 1–5, 2020.
  18. Jiang, P. Ye, G. Jin, Y. Qi, and H. Lin, “Optimization design to reduce detent force and standardize back-emf for permanent magnet synchronous linear motor,” in IECON 2016-42nd Annu. Conf. IEEE Ind. Electron. Soc., pp. 1716– 1720, IEEE, 2016.
  19. A.-K. Mohammed, F. M. Mohammed, and A. A. Raghda’a Ahmed, “Design and optimization of a surfacemounted permanent-magnet linear synchronous motor with maxwell ansys,” Al-Khwarizmi Eng. J., vol. 15, no. 3, pp. 1–15, 2019.
  20. Wang, B. Zhao, J. Zou, and Y. Li, “Minimization of cogging force in fractional-slot permanent magnet linear motors with double-layer concentrated windings,” Energies, vol. 9, no. 11, p. 918, 2016.
  21. Rusli, I. N. G. Wardana, M. A. Choiron, and M. A. Muslim, “Investigation of cogging forces using reluctance circuits equivalent approximation in a ladder secondary single-sided linear induction motor,” East.-Eur. J. Enterp. Technol., no. 2 (5), pp. 23–35, 2019.
  22. Liu, H. Yu, M. Hu, C. Liu, J. Zhang, L. Huang, and S. Zhou, “Cogging force reduction of double-sided linear flux-switching permanent magnet machine for direct drives,” IEEE Trans. Magn., vol. 49, no. 5, pp. 2275–2278, 2013.
  23. Rostami and M. Rostami, “Analysis of afpm machines with cylindrically shaped magnets using quasi-3d method,” COMPEL - Int. J. Comput. Math. Electr. Electron. Eng., vol. 36, no. 4, pp. 1168–1183, 2017.
  24. H. Sharifi, S. M. Seyedi, and A. S. Mobarakeh, “Quasi-3d analytical prediction for open circuit magnetic field of axial flux permanent-magnet machine,” in Fundam. Res. Electr. Eng.: Sel. Pap. First Int. Conf. Fundam. Res. Electr. Eng., pp. 533–548, Springer, 2019.
  25. Hao and Y. Wang, “Comparison of the stator step skewed structures for cogging force reduction of linear flux switching permanent magnet machines,” Energies, vol. 11, no. 8, p. 2172, 2018.
  26. Arand, “Optimization of pm segments shift angles for minimizing the cogging torque of yasa-afpm machines using response surface methodology,” J. Oper. Autom. Power Eng., vol. 9, no. 3, pp. 203–212, 2021.
  27. Habibinia, M. Feyzi, and N. Rostami, “A new method for computation of axial flux permanent magnet synchronous machine inductances under saturated condition,” J. Oper. Autom. Power Eng., vol. 6, no. 2, pp. 208–217, 2018.
  28. Tiegna, Y. Amara, and G. Barakat, “Validity domain of a quasi-3d multislice analytical model for synchronous axial flux machines with trapezoidal magnets,” Eur. Phys. J. Appl. Phys., vol. 70, no. 1, p. 10902, 2015.
  29. Jing, W. Tang, T. Wang, T. Ben, and R. Qu, “Performance analysis of magnetically geared permanent magnet brushless motor for hybrid electric vehicles,” IEEE Trans. Transp. Electrif., vol. 8, no. 2, pp. 2874–2883, 2022.
  30. N. Lamichhane, L. Sethuraman, A. Dalagan, H. Wang, J. Keller, and M. P. Paranthaman, “Additive manufacturing of soft magnets for electrical machinesa review,” Mater. Today Phys., vol. 15, p. 100255, 2020.
  31. Cui, Z. Sun, W. Xu, W. Zhou, and Y. Liu, “Comparative analysis of bilateral permanent magnet linear synchronous motors with different structures,” CES Trans. Electr. Mach. Syst., vol. 4, no. 2, pp. 142–150, 2020.
  32. Liu, J. Gao, S. Huang, and K. Lu, “Magnetic field and thrust analysis of the u-channel air-core permanent magnet linear synchronous motor,” IEEE Trans. Magn., vol. 53, no. 6, pp. 1–4, 2017.
آمار
تعداد مشاهده مقاله: 297
تعداد دریافت فایل اصل مقاله: 453


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب