آمار

تعداد نشریات26
تعداد شماره‌ها380
تعداد مقالات3,343
تعداد مشاهده مقاله5,045,257
تعداد دریافت فایل اصل مقاله3,444,281
Khalafian, F., Saffarian, A.. (1402). Providing Control Method Using UPQC and Wind Turbine to Reduce Voltage Drop and Harmonics During Distribution Network Faults. سامانه مدیریت نشریات علمی, 12(1), 14-25. doi: 10.22098/joape.2023.11043.1820
F. Khalafian; A. Saffarian. "Providing Control Method Using UPQC and Wind Turbine to Reduce Voltage Drop and Harmonics During Distribution Network Faults". سامانه مدیریت نشریات علمی, 12, 1, 1402, 14-25. doi: 10.22098/joape.2023.11043.1820
Khalafian, F., Saffarian, A.. (1402). 'Providing Control Method Using UPQC and Wind Turbine to Reduce Voltage Drop and Harmonics During Distribution Network Faults', سامانه مدیریت نشریات علمی, 12(1), pp. 14-25. doi: 10.22098/joape.2023.11043.1820
Khalafian, F., Saffarian, A.. Providing Control Method Using UPQC and Wind Turbine to Reduce Voltage Drop and Harmonics During Distribution Network Faults. سامانه مدیریت نشریات علمی, 1402; 12(1): 14-25. doi: 10.22098/joape.2023.11043.1820

Providing Control Method Using UPQC and Wind Turbine to Reduce Voltage Drop and Harmonics During Distribution Network Faults

Journal of Operation and Automation in Power Engineering
مقاله 2، دوره 12، شماره 1، 2024، صفحه 14-25    اصل مقاله (1.85 M)
نوع مقاله: Research paper
شناسه دیجیتال (DOI): 10.22098/joape.2023.11043.1820
نویسندگان
F. Khalafian1؛ A. Saffarian* 2
1Department of Electrical Engineering, Ahvaz Branch, Islamic Azad University, Ahvaz, Iran
2Department of Electrical Engineering, Faculty of Engineering, Shahid Chamran University of Ahvaz, Ahvaz, Iran
چکیده
Existing generators used in renewable wind Turbines (WT) that are connected to the power system at the distribution level need a sound power grid for proper operation. The purpose of this article is to simultaneously use Unified Power Quality Conditioner (UPQC), wind turbine and appropriate control system to achieve the lowest harmonic distortion and voltage drop during network faults. Also, in this article, in order to check the efficiency of different fact tools when there is a fault in the network, a comparison between UPQC performance with static VAR compensator (SVC) and distribution synchronous static compensator (D-STATCOM) was made and the obtained results were presented. The performed simulations are based on compensation of voltage decrease and increase as well as compensation of harmonic distortion caused by nonlinear loads. The results obtained in this article show that Using UPQC in the network was able to compensate for 100% of voltage drop and voltage increase in the network, while svc and D-Statcom equipment in the best case compensated for 98\% of voltage increase and 90\% of voltage decrease. UPQC also can be the best tool to eliminate network flow harmonics.  In the previous papers, the best value for harmonic current distortion was 1.67%, but our results showed that the harmonic distortion of the network current when using UPQC is 1.47%. Also the harmonic distortion of network current with SVC and D-Statcom is 5.67 and 4.87 percent, respectively. The capability of the equipment in compensating for short circuit fault current and protection of wind power plant is also evaluated. There was no change in wind turbine voltage during the use of UPQC and faults, and 1 P.U remained constant, but when using svc and D-Statcom equipment, the wind turbine voltage during the fault decreased by 0.3 and 0.5 P.U respectively.
کلیدواژه‌ها
Power Distribution Network؛ Wind Turbine؛ UPQC؛ SVC؛ D-Statcom
مراجع
  1. Prakash and N. Suparna, “Design and Simulation of Phase-Locked Loop Controller Based Unified Power Quality Conditioner Using Nonlinear Loads,” Int. J. Power Electron. Drive Syst. (IJPEDS), vol. 2, no. 4, pp. 417-423, 2012.
  2. Ghosh and G. Ledwich, “Power quality enhancement using custom power devices,” Kluwer Academic, 2002. Fujita and H. Akai, “The unified power quality conditioner: the integration of series- and shunt-active filters,” IEEE Trans. Power Electron., vol. 13, no. 2, pp. 315-322, 1998.
  3. K. Latha, et al., “Unified Power Quality Conditioner for Voltage Sag and Harmonic Mitigation of Nonlinear Loads,” Int. J. Power Electron. Drive Syst. (IJPEDS), vol. 1, no. 1, pp. 65-74, 2011.
  4. Singh, P. Venkateswarlu, “A Simplified Control Algorithm for Three-Phase Four-Wire Unified Power Quality Conditioner,” J. Power Electron., vol. 10, no. 1, pp. 91-96, 2010.
  5. Vinduja A, Labeeb, K. Nishada, “Controlling Methods for Single-Phase to Three-Phase UPQC Applied in Single Wire Earth Return Distribution Grids,” J. Eng. Techniq., vol. 4, no. 2, pp. 450–458, 2018.
  6. Lu., G Xiao. , X. Wang. , F. Blaabjerg, and Lu. D, “Control strategy for single-phase transformerless three-leg unified power quality conditioner based on space vector modulation,” IEEE Trans. on Power Electron., vol. vol. 31, no. 4, pp. 2840–2849, 2016.
  7. E. C. Santos , C. B. Jacobina, J. A. A. Dias, and N. Rocha, “Singlephase to three-phase universal active power filter”, IEEE Trans. On Power Delivery, vol. 26, no. 3, pp. 1361–1371, 2011.
  8. K. Singh, A. Kumar, A.R. Gupta, "Distribution System Analysis with UPQC Allocation Considering Voltage Dependent Time-Variant and Invariant Loads including Load Growth Scenario," J. Inst. Eng. India Ser. B 103, 791–807, 2022.
  9. V. D. Rama Rao and S. Pragaspathy, "Enhancement of Electric Power Quality using UPQC with Adaptive Neural Network Model Predictive Control," Int. Conf. Electron. Renewable Syst. (ICEARS), pp. 233-238, 2022.
  10. L. B. G, Silva. S. A, Oliveira Jr. O. A. A, and Bacon. V. D. . “Single-Stage Three-Phase Grid-Tied PV System with Universal Filtering Capability Applied to DG
  11. Systems and AC Microgrids,” IEEE Trans. Power Electron., Early Access, 2017.
  12. Chindris, A. Cziker and A. Miron, "UPQC — The best solution to improve power quality in low voltage weak distribution networks," Int. Conf. Modern Power Syst. (MPS), 2017, pp. 1-8, 2017.
  13. Samal, P.K. Hota, and P.K. Barik, "Performance Improvement of a Distributed Generation System Using Unified Power Quality Conditioner," Technol. Econ. Smart Grids Sustain. Energy, vol. 5, no. 24, 2020.
  14. H. Yang, and J. X. Jin, "Unified Power Quality Conditioner with Advanced Dual Control for Performance Improvement of DFIG-based Wind Farm," IEEE Tran. Sustain. Energy, 1–1, 2020.
  15. Murugan, B. Guruprasad, V. Perumal, and T. G. Arul, "Renewable Energy Based Grid System Using UPQC for PQ Improvement," J. Physics: Conf. Series, vol. 1964, 062094, 2021.
  16. P. Kumar, S. Pragaspathy, V. Karthikeyan and K. N. S. Durga Prakash, "Power Quality Improvement for a Hybrid Renewable Farm Using UPQC," Int. Conf. Artifi. Intelli. Smart Syst. (ICAIS), pp. 1483-1488, 2021.
  17. R. Reddy, A. V. S. Reddy, C. N. Kumar, M. I. Ahmed, D. R. Reddy, B Srikanth Goud, Flah Aymen, "Power Quality Improvement in Integrated System using Inductive UPQC," vol. 11, no. 2, 2021.
  18. G. Hemeida, Rezk, H., and M. M. Hamada, "A comprehensive comparison of STATCOM versus SVC-based fuzzy controller for stability improvement of wind farm connected to multi-machine power system," Elec. Eng., vol. 100, no. 2, 935–951, 2017.
  19. Prabhu, N., “Performance Analysis of Fuel Cell DSTATCOM”, ICEES Fifth Int. Conf. Elec. Energy Syst., 2019.
  20. Fuchs, E. and Masoum, M.A., 2011, "Power quality in power systems and electrical machines," Academic press.
  21. da Silva, A. Oliveira, and F. A. Negrão, “Single-phase to three-phase unified power quality conditioner applied in single-wire earth return electric power distribution grids,” IEEE Trans. Power Electron., vol. 33, no. 5, pp. 3950–3960, 2017.
  22. Yavari, S. H. Edjtahed, and S. A. Taher, "A nonlinear controller design for UPQC in distribution systems. Alexandria Eng. J., 2018.
  23. E. Leon, S.J. Amodeo, J.A. Solsona, M.I. Valla, Non-linear optimal controller for unified power quality conditioners, IET Power Electron., vol. 4, no 4, 435–446, 2011.
  24. Aredes, Active Power Line Conditioners, PhD Thesis, Technische Universität Berlin, Berlin, 1996.
  25. Fujita, H. Akagi, The unified power quality conditioner: The integration of series and shunt-active filters, IEEE Trans. Power Electron., vol. 13, no. 2, 315–322, 1998.
  26. V. Ramana Reddy a, K. Ravi a, C. Shilaja, “Squirrel cage induction generator to 140 bus weak distribution power grid connection using i-UPQC for voltage fluctuations”, Microelectronics J., vol. 92, 104607, 2019.
  27. Amoozegar, D., “DSTATCOM modelling for voltage stability with fuzzy logic PI current," Elec, Power Energy Syst., vol. 76, 129–135, 2016.
  28. W. Miller ,W. W. Price ,J. J. Sanchez-Gasca, “Dynamic Modeling of GE 1.5 and 3.6 Wind Turbine-Generators”, GE Power Syst., October 27, 2003.
  29. N, Shankar. S, “UPQC: A Custom Power Device for Power Quality Improvement” Elsevier, Materials Today: Proceedings, vol. 5, 965–972, 2018.
  30. Samal, H. Kumar, “Wind Energy Fed UPQC System for Power Quality Improvement,” Bulletin Elec. Eng. Informatics, vol. 7, no. 3, pp. 495 504, 2018.
  31. N. Jyothirmai, M. Srikanth, B. Sivanji, and V. Suresh, "An Enhancement of Power Quality in Grid Coordinated Wind Energy System Using Fuzzy Controlled UPQC," 2021.
  32. Vinothkumar, and R. Kanimozhi, "Power flow control and power quality analysis in power distribution system using UPQC based cascaded multi-level inverter with predictive phase dispersion modulation method," J. Ambient Intelli. Humanized Compu., vol. 12, no. 6, 6445-6463, 2021.
  33. Amini, and A. Jalilian, "Optimal sizing and location of open-UPQC in distribution networks considering load growth," Int. J. Elec. Power Energy Syst., 130, 106893, 2021.
  34. S. Dheeban, and N. B. Muthu Selvan, "ANFIS-based power quality improvement by photovoltaic integrated UPQC at distribution system," IETE Jo. Research, 1-19, 2021.
آمار
تعداد مشاهده مقاله: 785
تعداد دریافت فایل اصل مقاله: 857


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب